1/2 - 1-3/8" External Deburr Bit

Quickly repair ends on wheel studs, bolts, and threaded rod by removing burred and damaged ends

Easily repairs threads in place, eliminating the time and cost of replacing hard-to-find or expensive hardware

The 5 long lasting tungsten carbide cutting blades with a hardness rating between 88-90 HRC are durable enough to use on most metals leaving a clean thread end if used as directed

Operation: Using the lowest drill gear; rotate bit between 0 - 150 RPM and apply consistent forward pressure evenly, until the damaged threads have been removed

Bit capacity of 1/2 - 1-3/8" (13 - 36mm) and can be used with most materials including stainless steel, aluminum, plastic, or wood

NOTE: Use above recommended RPM or with hammer/impact drills will destroy cutting edge of tool